Fiber dimensions, lignin and cellulose content of various plant materials and their suitability for paper production

Published Date
May 2004, Vol.19(3):245–254, doi:10.1016/j.indcrop.2003.10.006

Author 

• C. Ververis ^a,,
• K. Georghiou ^a
• N. Christodoulakis ^a
• P. Santas ^b
• R. Santas ^b

• aDepartment of Botany, Faculty of Biology, University of Athens, GR 157 84 Athens, Greece
• bOikoTechnics Institute, 35 Androutsou, R. Fereou Street, GR 166 73 Voula, Greece

Received 11 December 2002. Accepted 20 October 2003. Available online 9 December 2003. 

Abstract

Fiber dimensions and lignin and cellulose content of various highly productive, non-wood plants and agricultural residues were examined to assess their suitability for paper production. Plants like kenaf (Hibiscus cannabinus L.) and giant reed (Arundo donax L.) internodes gave very good derived values, especially slenderness ratio, which is directly comparable to some softwood and most hardwood species. Cotton (Gossypium hirsutum L.) stalks, miscanthus (Miscanthus × giganteus) and switchgrass (Panicum virgatum L.) have shorter fibers resulting to poorer flexibility and Runkel ratios, but still satisfactory slenderness ratios. Finally, fibers from olive tree (Olea europea L.) and almond tree (Prunus dulcis L.) prunings presented relatively short and thick fibers producing the poorest derived values among all the species examined. Fiber dimensions did not differ significantly within each species, when samples from different stalks/branches or different positions (base, middle top) were examined. The only exception were cotton stalks, where those differences did not have any significant effect on fiber derived values.

Chemical analysis of the raw plant materials revealed satisfactory levels of α-cellulose content (close to 40%) and Klason lignin content (<30%) compared to those of hardwoods and softwoods. Relatively increased (>25%) lignin content in miscanthus, switchgrass and almond prunings may require additional pulping time and chemical charge compared to those of other non-wood raw materials. Analysis of samples at various heights/lengths of the plant materials showed that lignin and cellulose content depends on tissue maturity, but does not change significantly within each species.

Keywords

Fiber dimensions

Lignin and cellulose content

Non-wood plants

Agricultural residues

Mechanical strength

---

 Table 1

Table 1.

 Table 2

Table 2.

 Table 3

Table 3.

 Table 4

Table 4.

Fig. 1.

Fig. 2.

Fig. 3.

 Table 5

Table 5.

• *
  Corresponding author. Tel.: +30-210-7274467; fax: +30-210-7274656.

For further details log on website :
http://www.sciencedirect.com/science/article/pii/S0926669003001171