Mechanical properties of boards made in biocomposites reinforced with wood and Posidonia oceanica fibers

Published Date
Composites Part B: Engineering
1 November 2016, Vol.104:1–8, doi:10.1016/j.compositesb.2016.08.018

• Author 

• A. Maciá
• F.J. Baeza
• J.M. Saval
• S. Ivorra ^,

• Department of Civil Engineering, University of Alicante, Ctra. San Vicente del Raspeig s/n, 03690, San Vicente del Raspeig, Alicante, Spain

Received 6 April 2016. Revised 8 July 2016. Accepted 17 August 2016. Available online 20 August 2016. 

Abstract

The development of biocomposites has valorized some natural products related to natural processes or crop industries. In this regard, Posidonia oceanica is a marine phanerogam typical of Mediterranean coasts, in which due to tourism industry a lot of resources are destined to remove and treat Posidonia residues left on beaches. In this work an alternative to recycle this natural waste has been studied. Biocomposites with Posidonia and pine-wood particles were tested as an alternative to structural wood particle boards used in construction. Different substitution ratios (pine by Posidonia) were prepared in two different polymeric matrices and their mechanical properties were tested. Particles boards made in 75% Posidonia oceanica and 25% wood particles and a MDI matrix (20–30% by fibers mass) showed the best strength and stiffness to density ratios. This stiffness was even similar to a panel made totally in wood and MDI in the same dosage, i.e. 75% of pine fibers could be replaced by Posidonia with low stiffness loss.

Keywords

• Biocomposites
• Posidonia oceanica
• Recycling
• Mechanical properties
• Structural boards

---

Fig. 1.

 Table 1

Table 1.

 Table 2

Table 2.

 Table 3

Table 3.

 Table 4

Table 4.

Fig. 2.

Fig. 3.

Fig. 4.

Fig. 5.

 Table 5

Table 5.

Fig. 6.

Fig. 7.

• ∗ 
  Corresponding author.

© 2016 Elsevier Ltd. All rights reserved.

For further details log on website :
http://www.sciencedirect.com/science/article/pii/S1359836816302578